HELIX M SIX 6 Channel Car Audio amplifier 6x100w RMS

One for all – no matter if 3-way, 2-way or subwoofer application, the 6-channel amplifier M SIX will always be the right choice. 

With generously 100 Watts RMS per channel into both 4 Ohms and 2 Ohms load this amp really gets your speaker cones going despite its super-compact dimensions. On the other hand, the M SIX stays totally cool thanks to its highly efficient Class D design topology. And even bridged configurations are possible, delivering up to 3 x 200 Watts RMS of clean and undistorted output power. 

In addition, a comprehensive and stunningly practical feature set leaves nothing to be desired. And finally, the perfect sound tuning is no big deal thanks to its integrated crossover with all its setup options.

mall footprint Class D amplifier with high output power of 100 Watts RMS @ 4 and 2 Ohms load

Start-Stop capability down to 6V supply voltage

6-channel low-level input

Integrated, active crossover with highpass, lowpass, bandpass and subsonic

“Input mode” switch for channel E & F for flexible input signal routing

SMD (Surface Mounted Device) manufacturing technology combines minimum space requirement with maximum reliability

Exclusive, extremely compact and clean design with illuminated HELIX-logo and low heat dissipation thanks to extraordinary efficiency

Special features:

Start-Stop capability

The switched power supply of the HELIX M SIX assures operation even if the battery’s voltage drops down to 6 Volts during engine crank.

Output power RMS / max. 

- @ 4 Ohms 6 x 100 / 200 Watts

- @ 2 Ohms 6 x 100 / 200 Watts

- @ 1 Ohm -

- bridged @ 4 Ohms 3 x 200 / 400 Watts

- bridged @ 2 Ohms - 

Amplifier technology Class D

Inputs 6 x RCA / Cinch

1 x Remote In

Input sensitivity RCA / Cinch 0.5 - 6 Volts

Input impedance RCA / Cinch 20 kOhms

Input impedance highlevel - 

Outputs 6 x Speaker output

Output voltage RCA / Cinch - 

Signal converter for digital input - 

Frequency response 10 Hz - 30,000 Hz

Bass boost - 

Highpass 15 Hz - 4,000 Hz adjustable

Lowpass 40 Hz - 4,000 Hz adjustable

Bandpass 15 Hz - 4,000 Hz adjustable

Subsonic / HPF

15 Hz - 4,000 Hz adjustable

Phase - 

Slope high- / lowpass 12 dB/Oct.

Slope subsonic / lowpass - 

Signal-to-noise ratio digital input - 

Signal-to-noise ratio analog input 98 dB (A-weighted)

Distortion (THD) 0.05 %

Damping factor 100

Operating voltage 10.5 - 16 Volts (max. 5 sec. down to 6 Volts)

Idle current 1,550 mA

Fuse 2 x 35 A Maxi-fuse (APX)

Additional features Active, adjustable crossover, subsonic input mode switch channel E / F, subsonic, Start-Stop capability

Dimensions (H x W x D) 50 x 320 x 154 mm / 

2.00 x 12.60 x 6.06”

We take great care packaging every item to ensure safe shipment to you. Our postage and courier charges cover not only the shipping cost, but also the time to pack your order, plus packaging supplies, etc. please note - some items may incur extra shipping charges that have to be sent by courier and are too large / expensive to be sent by Royal Mail (for example headlamps, head units, speakers, lowering springs etc) to the following postcode areas, Channel Islands, BT, most IV, HS, KA-27-28, Any KW, AB30-56, FK17-99, G83, KW1-14, PA21-40, PH18-26, PH30-41, PH49-50, all ZE, IM, and any other non-mainland postcodes.